I went and compared the Tazer force RWD to the traction control button hold for 5 seconds. The Jeep behaved the same. I tried spinning my tires with the AWD normal set up. It was walking through my brakes without spinning. With the traction control button held for 5 seconds then trying the same the back wheels started with very very little effort. I did the same with the Tazer forced RWD and again spun the rear wheels with very little effort. In fact, when I force RWD with the Tazer while in drive I clearly feel something on the Jeep release. I feel the exact same thing release while in drive after holding the traction control button for 5 seconds….doing all this stopped but in drive. That all being said, I’m not sure what the functionality of it would be except to do a burn out with out a Tazer. My tires are too expensive for that, unless someone dares me and holds my beer. The picture with the deep tire marks are with the Tazer forced RWD and the TCB 5 second hold side by side. The picture with lighter burn marks side by side are TCB 5 second hold on the left with no front tire marks. If you look on the right you see where the front tires engaged after slight spin in the rear, that was in normal set up.