Recent content by Wizza

Badass setup start to finish....i like that you mounted the lp6 under the hoop, i was planning to do the same Am sure you will have a buyer soon

Got the GMRS45 radio plugged in and tested, created my FCC FRN and should be good to go soon.

no totally had the same thought about relocating it so it was smooth on the bottom I was listening to the call when the ship was in touch with MC directly. Part number was correct, but additional info was mentioned about diff casting variances that had been noted from MC that were of issue for...

As mentioned

thanks, will share a shot of mine later tomorrow, however the plate was NOT shaped so it closed the gap onto the gusset....so my shop had to use spacers to fill it and bolt together.

@Cali392JL can you show the driver side rear view of the front diff cover where the bolts are vertical on the side of the diff? trying to compare to what my shop was forced to do to get it on.

Mine gave the shop some trouble but they were able to get it done with use of spacers Will take a picture tomorrow Shop called MC and was told there were some variances in the diff casting on early 392 models like my 21 (covid parts) that made it tough to just mount up like the instructions state

There may be room for an extension but not a valve in my opinion The access hole as I recall from adding check valves would be a tight fit

All finished up on my 21 getting diff skids and Undercloak system done Fully pleased with results, even though I opted against the resonator part.